DPDT RELAY 24v as used on dINgO PCB

DPDT RELAY 12v as used on BIO500v2 PCB

PUSH NO PUSH OFF SPST Switch with red led  Switch type: Solder Tail SPST  Contact rating: 1.5A @ 250V AC  LED (typical voltage): 2V DC 20mA  Contact resistance: < 50mΩ  Insulation resistance: >100MΩ  Panel thickness: 0.75 - 3mm  Dialectric strength: >1500V AC 1 minute  …

PUSH NO PUSH OFF SPST Switch with red led  Switch type: Solder Tail SPST  Contact rating: 1.5A @ 250V AC  LED (typical voltage): 2V DC 20mA  Contact resistance: < 50mΩ  Insulation resistance: >100MΩ  Panel thickness: 0.75 - 3mm  Dialectric strength: >1500V AC 1 minute  …

DPDT Centre off toggle used on our LA500ASC PCB & NEW MAC RED RACKS (ON - OFF - ON)  with threaded bush with 2 nuts and lock washer. Same as image below but with 20mm+ long wire wrap legs

Rotary Switch 3 position 4 pole as used on our Passive Monitor PCB

Pot assembly used in PEQ500 for HI Cut / Boost with push for Shelf / push for Q switch and orange LED. Easiest way to fix a PEQ500 with orange led stuck in or off or or EQ stuck in Shelf or Q position.

Pot used in PEQ500 HI boost with push for Shelf / push for Q switch.

2 x 12 position Dual Rotary Switch with silver contact switching. Used for Gain Switch all of our  Dual99v500, NV500, 500/51X Mic pres & 1290 Macro Mic pre kit. Used for both LO & HI Frequency Switch in our PEQ500 EQ  MDS PCB to make dual switched pots with this switch here  …

DPDT Centre off toggle used on our MAC PCB (ON - OFF - ON)  with threaded bush with 2 nuts and lock washer.

DPDT toggle used on our BA, BAD, BAN, GO between & GO between PLUS PCBs (ON - NONE - ON) with threaded bush with 2 nuts and lock washer.

Large Toggle Switch PCB mount that is used in our power switch kits.